Once there, I was able to set user codes without issue. I vaguely remember having my better half hold down two buttons on one of the key pads while I power cycled at the main panel, then entering the default installer code to put it into program mode. I thought I had read that it only worked if the installer code was still set to default, but maybe it was just a lock thing. I can see where you might think that though, and I apologize if I came off that way.īack to the subject at hand, what you said about the installer code sounds familiar. If I was spamming, I'd have probably linked to websites, or some other shit, but you're free to make that assumption. I just happened to use that particular system to replace my Vista panel, and so far, had been happy with it. While browsing posts for info, I came across this thread, and figured I'd offer what I though was helpful info. I've been very pleased with mine so far.Īctually, I registered here because I'm looking to install cameras at my house, and have no prior experience. It's infinitely expandable and quite affordable. The system connects to your WiFi, and talks to SmartThings and Home Assistant (home automation platforms), allowing you to configure your system the way that works best for you, and monitor via your mobile device. They sell small modules with proprietary (but open source) firmware that allows you to connect up to 6 independent zones per module. One single solution when an alarm keeps beeping is this: If. If you're the DIY type, and want to use all of your existing sensors, but replace the main alarm controls and avoid paying a professional monitoring service, you should look into Konnected. Take the systems backup battery out of the alarm keypad. I think I was able to get through the process in less than 5 minutes. This only works if the installer code was not changed from the default pin, but it seems most installers leave them at default. I was able to find a how-to article explaining how to use an installer code to change the user codes. Service was cancelled prior to sale, and we never had the keypad codes. Actual battery life may be reduced by humidity, fluctuating temperatures, and other factors in the environment where the sensor is used. Previous owner had used a Honeywell Vista system, monitored by a local company. Batteries in the wireless sensors of your Honeywell alarm system such as the keypad, smoke detectors, and the personal emergency transmitter typically last for 1 to 4 or more years. Had a similar situation when we bought our house a few years ago.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |